Electronics For Imaging Pi6500 Pro Wartungshandbuch PDF herunterladen (Seite 120)

4-16 Setting up Network Servers

TO SET UP FIERY WEBTOOLS ON THE FIERY X3

1. Perform Fiery X3 Setup and enable TCP/IP.

In Network Setup, choose Protocol Setup and perform TCP/IP Setup and Ethernet

Setup.

2. Set a valid, unique IP address for the Fiery X3, and then set the subnet mask and a

gateway address if necessary.

3. Exit TCP/IP Setup and exit Protocol Setup.

4. Choose Service Setup, and choose Web Services Setup.

5. For Enable Web Services, select Yes.

6. Exit Service Setup and exit Network Setup, and select Yes at the Save Changes screen.

TO SET UP FIERY WEBTOOLS ON A COMPUTER

1. Enable TCP/IP networking.

2. Assign the workstation has a valid, unique IP address, and then set the subnet mask.

Set a gateway address if necessary.

3. Install an Internet browser that supports the Java language and frames.

Make sure Java is enabled.

See Getting Started for more information on supported browsers and other

Fiery WebTools requirements.

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 151 152

Keine Kommentare

Electronics For Imaging Pi6500 Pro Wartungshandbuch Seite 120